Slant *        6        Forum
Home Home Home
The Place to Go for Slant Six Info!
Click here to help support the Slant Six Forum!
It is currently Thu Mar 28, 2024 10:34 pm

All times are UTC-07:00




Forum locked  This topic is locked, you cannot edit posts or make further replies.  [ 2 posts ] 
Author Message
PostPosted: Sun Apr 07, 2002 10:24 am 
I'm thinking of porting and polishing the head on my car. Would this benifit any performance aspects on a daily driver? If so do you have any specs so I can take to the machine shop.

bigman6969170335@aol.com


Top
   
PostPosted: Sun Apr 07, 2002 10:42 am 
(User Above) wrote:
: I'm thinking of porting and polishing the head
: on my car. Would this benifit any
: performance aspects on a daily driver? If so
: do you have any specs so I can take to the
: machine shop.


Just grind-out the sharp edge roght under the valve seat, right where the machined angle meets the rough "as cast" port surface. Grind-off any other rough edges or bumps you see and you are set.
DD


Top
   
Display posts from previous:  Sort by  
Forum locked  This topic is locked, you cannot edit posts or make further replies.  [ 2 posts ] 

All times are UTC-07:00


Who is online

Users browsing this forum: No registered users and 7 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Limited