need a pair tks

PM sent.
DD

You'll love them!

_________________
If it was easy, everybody would be doing it.

I want me a set but I'm a poor 18 yo with no job so I'm gonna make my own and see how they come out.

_________________
64 dart GT /225
...........____ .
...._n_.[____].
..@\...\=| |....
....\.\...\ //....
.....L\....\......
.......\____\....

By the time you saw, measure, cut, heat, grind, weld, cuss, and redo it a couple times, you could just rake leaves or snow for the neighbors and save up enough for a set. maybe Santa can kick in a few bucks. Certainly it's do-able, but why go to all the trouble?
A Dutra set has cut out all the guesswork. Mine fit as if Chrysler had made them... right out of the box.

_________________
If it was easy, everybody would be doing it.

This is off topic but how good are these with a turbo, or maybe two small turbos? I might be interested in building a turbo 225 and like a clean looking exhaust set up that is not too cluttered ( especially around the starter). I appreciate the work that Doug has done.

how much is a pair?

_________________
-Christopher

"Gray Ghost"-1970 Dart.
"Frederick II"-1994 Geo Metro.

Pricing starts at $250.00 for a single Dutra casting, ready to install...
The cost of the rear manifold is based on what you do... either modify a factory exhaust manifold or use another new Dutra casting, machined to fit the rear 3 cylinders. (Dual Dutra Duals)
DD