Slant Six Forum
https://www.slantsix.org/forum/

Setting the mixture on the Carter BBD
https://www.slantsix.org/forum/viewtopic.php?f=19&t=61738
Page 1 of 1

Author:  gdizzle [ Sat Dec 16, 2017 3:57 pm ]
Post subject:  Setting the mixture on the Carter BBD

I am trying to follow the directions for setting the mixture idle on my Super Six Carter BBD carb, on my slant 66 dart.

The issue is since I have converted to the super 6, it has some limiter in the carb that keeps it from getting too rich. So I can screw the screws inward, and I can get it to stall. But I can not screw them outward to get it to stall. If I am supposed to dial it in , how do I figure out how far out they go before I should start screwing them inward??

So once I screw them inward, and I get bad sounds, how far should I back them out?? Yes I have vacuum gauge but it doesnt help with the screwing outward. no change

Page 1 of 1 All times are UTC-07:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/