Slant Six Forum https://www.slantsix.org/forum/ |
|
Hagerstown (Mason Dixon) Race May22 & 23, 2010 https://www.slantsix.org/forum/viewtopic.php?t=38550 |
Page 8 of 22 |
Author: | Rick Covalt [ Wed Apr 28, 2010 11:08 am ] |
Post subject: | Breaking out |
By running out he means break-out. That is if you run faster than your dial-in. If you dial in at 18.00 and run 17.99 you broke out and lost. That is, unless your opponent broke out also, and then whoever ran to fast by the least amount wins. Rick |
Author: | Dart270 [ Wed Apr 28, 2010 11:13 am ] |
Post subject: | |
You pretty much have it covered! The words are "break out" not runout. That means you ran an ET that was faster (smaller number in seconds) than your dial in. Usually you do not go directly back to the lanes for the next round if you win, but go back to pits and wait for the call for winners to get in the lanes again. Also, it is not only the reaction of your eye-brain-foot-gas that takes most of the time between the last yellow and the green, it is also the reaction of the car to actually start moving after you mash the gas. This can take 0.2-0.7 sec depending on the car and launch technique. Pat, you will have a ball and the Slanted Family will teach you some tricks when we're at the track. Lou |
Author: | Pat Dawson [ Fri Apr 30, 2010 11:12 am ] |
Post subject: | |
Sounds like a plan, Lou. Looking forward to the event and meeting my fellow slanters. |
Author: | Rick Covalt [ Sat May 01, 2010 1:41 pm ] |
Post subject: | Trophies are in |
I picked up both trophies for our races yesterday. If someone wins both days they will have 2 nice bookends! Just got home from Mason Dixon, Test & Tune, and anyone that is worried about being slow. You will only be 2nd slowest vehicle there. Take my word for it. They ran 2 cars in the lane beside me, one after another and they still both beat me! ![]() ![]() ![]() ![]() One thing that is very difficult to do with a 4 speed with stock (quiet) exhaust, and no tach is to hear your own engine. I am not worried about it for shifting because I shift at 35 MPH, and 55 MPH. But on the line it was hard to hear anything beside an open headered car. I may need to grab a cheap tach before the 22nd. I had a good time but it was stickin hot! See you all at Mason Dixon on the 22nd & 23rd. Rick |
Author: | turboram [ Sun May 02, 2010 9:09 am ] |
Post subject: | |
I'm get'n excited ![]() |
Author: | Rick Covalt [ Sun May 02, 2010 12:21 pm ] |
Post subject: | Bump |
Just thought I'd bump the list forward. We are getting close here. If there are any changes in your status on attending, please let me know. Rick Udated List 5/5/10 Day One Racing Saturday Seymour Pederson Rick Covalt Ryan Covalt Denny Covalt Lou Madsen 1 Lou Madsen 2 Greg Ondayko Ron Hamby Phil Stonebeck Charles Brooks Jr Ron Parker Brian Mimken Ron Heath Frank Brent (66acuda) Brian Droschack 1 Brian Droshack 2 Turboram Chris (Valiant one) Day Two Racing - Sunday Seymour Pederson Ron Rarker Ron Hamby Brian Mimken Ryan Covalt Rick Covalt Denny Covalt Lou Madsen 1 Lou Madsen 2 Fzmax Greg Ondayko Phil Stoneback Romeo Furio Charles Brooks Jr Don (65 Dartman) 64conv65hard (Kevin) Pat Dawson Ron Heath Frank Brent (66acuda) Brian Droschack 1 Brian Droshack 2 Larry Chesney Turboram Chris (Valiant one) Maybe list? Tony Walker Maynard Gress Charlie S. Greg's dad Sam Powell Rodney Hargis Cory Ruhl (75customdart) |
Author: | ValiantOne [ Wed May 05, 2010 7:35 am ] |
Post subject: | |
Ok, I am going to try and run my 67 Dart slanter at Mason Dixon ![]() I have not made enough progress on my other car to run it, so if I want to run anything at all it is going to be my slant! However, I need to get this stupid vibration figured out and install a tach. And I need someone to tell me what my rev limit is with a stock cluch, flywheel and pressure plate, 'cause I like my feet where they now reside. I am going to post in the Trans and Rearend section on the vibration problem b/c I think that is where it is coming from. Please help! Rick, should I call you or sumpin'? Thanks all, Chris |
Author: | 75customdart [ Wed May 05, 2010 7:53 am ] |
Post subject: | |
Well guys i think your gonna have to count me out of the races. I just haven't had the time and funds to get my car together yet. But i'll be there to watch and help out turning wrenches for anyone who needs it! I'll be driving down in my 94 dakota with an off brand v8. Hey at least its half mopar. |
Author: | Rick Covalt [ Wed May 05, 2010 1:22 pm ] |
Post subject: | Got it! |
No need to call me Chris. I got the message. Are you planning to race both days? Hopefully yes. ![]() 75customdart, Sorry you can't race but still glad your coming anyway. Rick |
Author: | 66aCUDA [ Thu May 06, 2010 5:49 am ] |
Post subject: | |
Ill be bringing the Aussie Speed Products to the race so if anyone needs something I should have it. Should have a stocking stuffer or 2 as well. Frank |
Author: | Rick Covalt [ Thu May 06, 2010 9:12 am ] |
Post subject: | Any Questions |
Anybody have any questions for the track? I will be sending him a note shortly and will be glad to ask anything you might have. Frank, Thanks for bringing the Aussie speed stuff. Rick |
Author: | ValiantOne [ Thu May 06, 2010 9:57 am ] |
Post subject: | Re: Got it! |
Rick, Yes I am planing to do both days. On Sat I'm hoping you guys can get me square on what the heck to do. I've never done this before! Whoohooo! C ![]() Quote: No need to call me Chris. I got the message. Are you planning to race both days? Hopefully yes.
![]() 75customdart, Sorry you can't race but still glad your coming anyway. Rick |
Author: | Charrlie_S [ Thu May 06, 2010 11:40 am ] |
Post subject: | |
I'm still a "maybe" for both days, but looking more possible. The upside:I have been very busy with paying jobs, and it looks like the money will be there. The downside: I have been busy with paying jobs, so the race car isn't ready, yet. |
Author: | Rick Covalt [ Thu May 06, 2010 1:52 pm ] |
Post subject: | Great news |
Not to worry Chris. We have plenty of "Rookies" who are coming to race. We will have a meeting and go over things with everyone each day. Charlie, That is good news. We will have our fingers crossed that it all works out. Rick Covalt |
Author: | Greg Ondayko [ Thu May 06, 2010 8:25 pm ] |
Post subject: | |
Dont go over 4800 On the Stock pp Chris - No guarantee but That's What I would do. Remind me(send me an email) and I can bring my tranny Blanket that I used on the Dart - 10 minutes to install. Greg |
Page 8 of 22 | All times are UTC-07:00 |
Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |