Slant Six Forum
https://www.slantsix.org/forum/

Compression Ratio - Can't Confirm!
https://www.slantsix.org/forum/viewtopic.php?t=15526
Page 2 of 2

Author:  70valiant [ Tue Dec 27, 2005 4:36 pm ]
Post subject: 

after taking 0.100" off the head I ended up with 39-41cc chambers, at 30over, 0.140" deck and a felpro gasket(0.040") I am at a calculated ratio of 9.7-9.8 to 1. I gotta run premium fuel. :roll:
it was a little higher than I wanted but it runs like a scalded bear.

Author:  Ron Parker [ Tue Dec 27, 2005 5:00 pm ]
Post subject: 

If a stock Slant has some where between 110 to 140 psi compression and my engine has 200 psi can i whup Bagel Thanks Possum :D :D











Using A North Carolina Moonshiner to Blow up A Bagel

Page 2 of 2 All times are UTC-08:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/