FWIW - Clifford headers for a truck with the high starter:
-S/6
| Slant Six Forum https://www.slantsix.org/forum/ |
|
| anybody know anything abouth these? https://www.slantsix.org/forum/viewtopic.php?t=17060 |
Page 2 of 2 |
| Author: | Super6 [ Mon Apr 17, 2006 11:32 am ] |
| Post subject: | |
FWIW - Clifford headers for a truck with the high starter: -S/6 |
|
| Author: | 75duster [ Mon Apr 17, 2006 2:37 pm ] |
| Post subject: | |
ok those look like the silver set though they are in much better shape. im just going to get some PVC tubing and heat and bent it to match and set it in the engine bay chris |
|
| Author: | 75duster [ Mon Apr 17, 2006 8:15 pm ] |
| Post subject: | |
ok took some pvc pipe and wired it to the outside of the header where the pipe is for cylinder #2, heated and bent it to the same curves and cut to length. then when i put it in the car i noticed that the only way it would fit is to put the pipes through the hole in the k-member. is this normal? this is for the front section. chris |
|
| Author: | NewLancerMan [ Mon Apr 17, 2006 9:57 pm ] |
| Post subject: | |
Quote: could you take some pics? that way i could compare them
Here you gochris 
|
|
| Author: | 75duster [ Mon Apr 17, 2006 10:30 pm ] |
| Post subject: | |
ok is that a 6-1 setup? i would rather have 2 seperate outlets so i can run duals. the ones i have look like they need to go through the area where the k member splits and then go out under the chassis. im planning on doing the swap this weekend and would like the car to not be down for very long |
|
| Author: | AndyZ [ Fri Apr 28, 2006 5:35 pm ] |
| Post subject: | |
Quote: FWIW - Clifford headers for a truck with the high starter: That slant looks good in yellow!
-S/6 |
|
| Page 2 of 2 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|