| Slant Six Forum https://www.slantsix.org/forum/ |
|
| Need input on shaping aluminum. https://www.slantsix.org/forum/viewtopic.php?t=24549 |
Page 2 of 2 |
| Author: | DionR [ Wed Aug 22, 2007 9:11 am ] |
| Post subject: | |
Quote: Because right now it looks like you have all the ability you need, but you just don't have access to the right equipment.
Don't know, the ability seems in question too.  I will keep that in mind, thanks for the offer. I did make some progress with a sanding drum in a drill last night. Just a test, but it seemed to work, even though it was slow. |
|
| Author: | slantzilla [ Wed Aug 22, 2007 2:25 pm ] |
| Post subject: | |
What you need to find is a shop with a drum sander that does the pogo stick thing. If you were here I could fix you up.
|
|
| Author: | DionR [ Wed Aug 22, 2007 3:54 pm ] |
| Post subject: | |
Quote: If you were here I could fix you up.
Didn't Sandy make that drive?That's the problem with internet forums, everybody has to live so far away. |
|
| Author: | slantzilla [ Wed Aug 22, 2007 5:02 pm ] |
| Post subject: | |
Quote: Quote: If you were here I could fix you up.
Didn't Sandy make that drive?That's the problem with internet forums, everybody has to live so far away. Yes, Sandy was here, and it was about the halfway point of the adventure.
|
|
| Page 2 of 2 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|