| Slant Six Forum https://www.slantsix.org/forum/ |
|
| rear end https://www.slantsix.org/forum/viewtopic.php?t=7459 |
Page 2 of 2 |
| Author: | Pierre [ Mon Nov 10, 2003 3:08 pm ] |
| Post subject: | |
Whoa good call Nosser. If you looked further up at the brakedown diagrams, the one for the 8 3/8" (same housing as the 8 1/4" but different guts) that is evident. |
|
| Author: | DusterIdiot [ Mon Nov 10, 2003 3:18 pm ] |
| Post subject: | Guts aren't too different... |
an 8 3/8" (truck 8 1/4") can swap the ring and pinion, and 'sure-grip' to the 8 1/4" and I also hear that the bearings can be used as long as the original races go with it.... -D.Idiot |
|
| Author: | Pierre [ Mon Nov 10, 2003 3:20 pm ] |
| Post subject: | |
Right DI, but what I meant was you couldn't use an 8 3/8" ring gear with an 8 1/4" pinion. |
|
| Author: | DusterIdiot [ Mon Nov 10, 2003 4:44 pm ] |
| Post subject: | Gotcha! |
|
|
|
| Page 2 of 2 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|