| Slant Six Forum https://www.slantsix.org/forum/ |
|
| Roller Cam Interest List https://www.slantsix.org/forum/viewtopic.php?t=47352 |
Page 3 of 3 |
| Author: | billdedman [ Wed May 02, 2012 2:23 pm ] |
| Post subject: | |
I would definitely be interested in a roller-tappet, finished cam, but only IF it had a LSA around 114-115 degrees (my car is turbocharged.) Maybe a surcharge could be added to cams with other-than-normally-produced LSA angles??? I'd hate to trash the whole project on a squable over N-A. vs. Forced Induction LSA's. I feel it's far too important not to try to work out some sort of solution on that score. Thanks for your efforts!!! Bill, in Conway, Arkansas |
|
| Author: | madmax/6 [ Wed May 02, 2012 8:37 pm ] |
| Post subject: | |
Add me to the list IF it can bee ground identical to the cam I am runnining.Guzzi Mark |
|
| Author: | CNC-Dude [ Wed May 02, 2012 8:44 pm ] |
| Post subject: | |
Do your specs fall within the guidelines listed so far. |
|
| Author: | ceej [ Thu May 03, 2012 6:13 am ] |
| Post subject: | |
I haven't seen your cam card Mark. CJ |
|
| Author: | ceej [ Thu May 03, 2012 4:30 pm ] |
| Post subject: | |
Just got off the phone. The window isn't going to be very big for a given blank. We may be looking at a naturally aspirated blank and an adder blank. Ken won't be back until next week, so I'll need to talk to him to see if this is in the cards. From the conversation, lift isn't going to be an issue. LSA will be more critical. So, lets get more feedback about what people want. Once I can compile a list of NA cams and Adder cams, we can see if we have enough common ground to make it work. CJ |
|
| Author: | Dart270 [ Fri May 04, 2012 6:33 am ] |
| Post subject: | |
Sounds good, CJ. Thanks for the legwork. Haha, common ground... Lou |
|
| Page 3 of 3 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|