Thanks Rob! If it doesn't work out I'm fine with that too. Mine will set on the shelf for a while too!
| Slant Six Forum https://www.slantsix.org/forum/ |
|
| Wiseco Big Bore pistons ANOTHER RUN!! https://www.slantsix.org/forum/viewtopic.php?t=68441 |
Page 5 of 5 |
| Author: | Greg Ondayko [ Thu Apr 30, 2026 11:45 am ] |
| Post subject: | Re: Wiseco Big Bore pistons ANOTHER RUN!! |
I can go for a set 3.504" or a set of 3.484". Whatever is best to complete the buy. Greg |
|
| Author: | Dart270 [ Thu Apr 30, 2026 2:36 pm ] |
| Post subject: | Re: Wiseco Big Bore pistons ANOTHER RUN!! |
I'm in for a 3.485" set, assuming that will help complete the buy. Thanks, Rob! Lou |
|
| Author: | Rob Simmons [ Sat May 02, 2026 6:14 am ] |
| Post subject: | Re: Wiseco Big Bore pistons ANOTHER RUN!! |
This is the current list of people wanting these pistons. I don’t know if this will be enough to get them to make a run or not. I’ll report back next week. Pro-Tru Chrysler 225 Slant 6 Compression height - 1.625 Wrist pin - .901 PT112H84 - $650 per kit PT112H104 - $650 per kit Rings XX style ring 1.0 x 1.2 x 2.8mm; Gas nitride top ring; Napier scraper 2nd; Flex-vent style oil set Roll Call: Rick Covalt - 3.504” x 1 Greg Ondayko - 3.504” x 1 Wayne Venable - 3.485” x 1 Lou Madsen - 3.485” x 1 IdahoCarson (FABO) - 3.504” x 1 Matt - ??? x 1 CJ - ??? I ordered a set of the cast crank rods to get us to the minimum required. I’m not in a position to do that for a set of pistons that will also set on the shelf until my estate sale… Hopefully Adam will be able to make a run with just 5-7 sets. More to follow. |
|
| Author: | Rick Covalt [ Sat May 02, 2026 8:03 am ] |
| Post subject: | Re: Wiseco Big Bore pistons ANOTHER RUN!! |
Thanks Rob! If it doesn't work out I'm fine with that too. Mine will set on the shelf for a while too!
|
|
| Page 5 of 5 | All times are UTC-07:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|