Quote:
Ceej, could you contact OCG and see what they charge to finish grind a round lobe roller blank and heat treat one for a Slant 6.
Will make the call! 
CJ
| Slant Six Forum https://www.slantsix.org/forum/ |
|
| Roller Cams, the other aluminum head thread https://www.slantsix.org/forum/viewtopic.php?t=47333 |
Page 6 of 6 |
| Author: | Dart270 [ Wed Jan 25, 2012 1:15 pm ] |
| Post subject: | |
That is sounding more affordable, CNC-Dude. Thanks for the lobe size info, Doc. Lou |
|
| Author: | ceej [ Wed Jan 25, 2012 5:15 pm ] |
| Post subject: | |
Quote: Ceej, could you contact OCG and see what they charge to finish grind a round lobe roller blank and heat treat one for a Slant 6.
Will make the call! CJ |
|
| Author: | DusterIdiot [ Wed Jan 25, 2012 7:28 pm ] |
| Post subject: | Lol... |
Quote: Will make the call!
Tell him your name's Dave and you are replacing your current cam with something more durable and see if he'll cut you a deal...  ...then again last time I talked to them about that subject the guy was laughing saying "I told him it's going to wear out one day, I can't believe it's run this long!!!!".... -D.Idiot |
|
| Author: | CNC-Dude [ Wed Jan 25, 2012 11:28 pm ] |
| Post subject: | |
Thanks Lou, I think that is priced more realistically than what others have had to pay in the past for one. |
|
| Page 6 of 6 | All times are UTC-07:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|