| Slant Six Forum https://www.slantsix.org/forum/ |
|
| 2 bbl intake q https://www.slantsix.org/forum/viewtopic.php?t=10131 |
Page 1 of 1 |
| Author: | argentina-slantsixer [ Mon Aug 16, 2004 5:02 pm ] |
| Post subject: | 2 bbl intake q |
Hey there Would it make much diffrence if I can weld a mani for placing the carb 90deg rotated? (the 2 barrels placed one pointing to front of the engine and the other to the back?) rather than using the stock 2 bbl mani? I'm about using a holley 2300 and the size of the intake manifold "window" is too narrow compared to the holley's... (I know that I should use the adapter plate, I know, but still it's kinda huge diffrence between carb bores and manifold bore) |
|
| Author: | SlantSixDan [ Tue Aug 17, 2004 4:09 pm ] |
| Post subject: | |
"Parallel" 2bbls have been done, and there are advantages to doing it this way -- you can put in a vertical divider bar (weld to the floor of the intake) between the front and rear barrels to help reduce cross-pull and improve torque. |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|