| Slant Six Forum https://www.slantsix.org/forum/ |
|
| is there a bolt pattern for exhost manifold https://www.slantsix.org/forum/viewtopic.php?t=10538 |
Page 1 of 1 |
| Author: | Gunner12 [ Fri Oct 01, 2004 9:47 pm ] |
| Post subject: | is there a bolt pattern for exhost manifold |
I was wondering if there is a bold pattern on a 225 slant 6 also if there is any torc patterns thanks Gunner |
|
| Author: | Doctor Dodge [ Sun Oct 03, 2004 7:49 am ] |
| Post subject: | |
Torque the manifolds to 10-15 ft lbs and start from the middle and work outward in an even fashion. The idea is to tighten down the assembly in a way the "squeezes" the gasket out the ends so it does not wrinkle. DD |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|