| Slant Six Forum https://www.slantsix.org/forum/ |
|
| truck flywheel https://www.slantsix.org/forum/viewtopic.php?t=10614 |
Page 1 of 1 |
| Author: | sixty4dartgt [ Sat Oct 09, 2004 6:35 pm ] |
| Post subject: | truck flywheel |
As far as the slant 6 truck flywheels go, how many different ones were made? I thought the truck had a 11" 143 tooth wheel. I heard someone said their truck flywheel, with a 2 1/8 crank ID, had 132 teeth. Anyone heard of that? Does anyone know what the crank ID is on the 11" truck flywheel? 
|
|
| Author: | DusterIdiot [ Sat Oct 09, 2004 8:10 pm ] |
| Post subject: | There are two... |
Behind the later OD trannies those come with a standard size flywheel like in the cars, but are heavier for torque and come with the 10" clutch. If you get one with a low mount starter and a straight 4 speed in early trucks or a NP235/435 it should be a larger 11" clutch unit. -D.Idiot |
|
| Author: | Doctor Dodge [ Sun Oct 10, 2004 10:41 am ] |
| Post subject: | |
Quote: Does anyone know what the crank ID is on the 11" truck flywheel?
The 143 tooth NP 435 flywheels I have seen all had the small crank hole. .(60-67 SL6)This large flywheel can only be used with the matching bellhousing that has the low V8 starter position. (and it weighs a lot) DD |
|
| Author: | DusterIdiot [ Sun Oct 10, 2004 10:14 pm ] |
| Post subject: | And beyond... |
Last year I sold one out of an 80's truck to a member in Washington for his Ramcharger project that needed the special bell and flywheel, so they did make them for the larger crank pocket. -D.Idiot |
|
| Author: | VDART [ Mon Oct 11, 2004 4:23 am ] |
| Post subject: | flywheel stuffing |
Hello, been reading this post, I just sold an 11" flywheel, & the bellhousing (seperate buyers). The bellhousing was aluminum & it came from a 1960 Valiant, appearing to be original. Just FYI |
|
| Author: | kesteb [ Mon Oct 11, 2004 3:30 pm ] |
| Post subject: | |
I have a complete 11" setup out of a '80 1/2 ton. The bellhousing is setup for a 3 speed or the granny low 4 speed. |
|
| Author: | sixty4dartgt [ Mon Oct 11, 2004 10:32 pm ] |
| Post subject: | |
Do you know how many teeth on the '80 1/2 ton? Has anyone heard of a 132 tooth flywheel (factory)? |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|