I just threw a 170 in the scrap dumpster because I couldn't give it away.
| Slant Six Forum https://www.slantsix.org/forum/ |
|
| Where to find a slant six engine https://www.slantsix.org/forum/viewtopic.php?t=11272 |
Page 1 of 1 |
| Author: | RScott [ Fri Dec 24, 2004 1:40 pm ] |
| Post subject: | Where to find a slant six engine |
Where would someone who lives in S. California most likely to be able to find a slant six engine to start a new project? Would prefer a 170. Also, does anyone produce new crankshafts for these engines? I am familiar with the parts available from Clifford Performance. |
|
| Author: | Guest [ Fri Dec 24, 2004 4:24 pm ] |
| Post subject: | |
I know you can find them on ebay seen one for $50 bucks just have to keep looking |
|
| Author: | 63Dart [ Sat Dec 25, 2004 1:37 pm ] |
| Post subject: | |
Since the slant was in production for around a quarter century, it should not be hard to find one. You should have a number of "yards" down there like "Pick-A-Part" or "Pull-A-Part." These are huge junkyards where you just pull the part you need. There might also be places that sell engines that have already been pulled. Check your yellow pages. I'm guessing that you won't find too many 170's at the yards, but it's worth a try. The slant was used in TONS of Dodge/Plymouth vans and trucks, and was available in pretty much all rear drive Mopar vehicles up until the early 80's. |
|
| Author: | slantzilla [ Sun Dec 26, 2004 7:14 am ] |
| Post subject: | |
I just threw a 170 in the scrap dumpster because I couldn't give it away.
|
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|