| Slant Six Forum https://www.slantsix.org/forum/ |
|
| intake /exhaust gasket https://www.slantsix.org/forum/viewtopic.php?t=11359 |
Page 1 of 1 |
| Author: | redworm67 [ Wed Jan 05, 2005 10:59 am ] |
| Post subject: | intake /exhaust gasket |
what is the best intake/exhaust gasket for use with an aluminum intake and headers....what about dead soft copper or aluminum? would the intake manifold seal with a custom gasket from either of these previously mentioned materials?many thanx in advance... |
|
| Author: | Super6 [ Wed Jan 05, 2005 2:03 pm ] |
| Post subject: | |
I like & use Mr. Gasket PN 320G. Nice, thick gasket that rids you of the headache of trying to get the headers to seal properly to the head. -S/6 |
|
| Author: | zedpapa [ Wed Jan 05, 2005 4:09 pm ] |
| Post subject: | where from? |
where do you find the gaskets at, summit? do you remember how they cost? zedpapa |
|
| Author: | Super6 [ Wed Jan 05, 2005 4:49 pm ] |
| Post subject: | |
Here it is on Summit. They list it at a little under $16. I simply order mine through my local NAPA. After shipping (to Alaska mind you) I get them for about $20. -S/6 |
|
| Author: | Pyper6970 [ Wed Jan 05, 2005 4:51 pm ] |
| Post subject: | |
Never had a problem with the Fel pro gaskets, I have the Offy 4bbl intake and the Clifford duals, zero leaks. |
|
| Author: | Ron Parker [ Wed Jan 05, 2005 6:47 pm ] |
| Post subject: | |
Cox Bros in Columbus Ohio 614-268-9920 put one of there gaskets on in 2002 ran all year took it off that engine put on my racing engine and have took the intake/exhust off three times and there good to go. Extra thick about a 1/4 thick and that dog will hunt. Not that pricey. When it works doint screw it up. Thanks Ron Parker Hell Hath No Wrath Than A Possum Scorned |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|