Slant Six Forum
https://www.slantsix.org/forum/

turn signal changing tips on a 65 ?? HELP!
https://www.slantsix.org/forum/viewtopic.php?t=11671		 Page 1 of 1
Author:  65wggnguy [ Tue Feb 08, 2005 8:57 am ]
Post subject:  turn signal changing tips on a 65 ?? HELP!
Hello I was wondering if anyone has any tips on changing a turn signal mechanism on a 65 Valiant. I just got a new one fro mfreddrick dodge and was attepting changing my broken one last night and had no luck after 4 hours. I have changed a couple before, however have forgotten on the trick that I used, PLEASE HELP as I am not able to drive to work THANX
Author:  SlantSixDan [ Tue Feb 08, 2005 1:10 pm ]
Post subject: 
What "mechanism" is it that you're trying to replace? Just the turn signal cam, or the entire switch?
Author:  Guest [ Tue Feb 08, 2005 2:00 pm ]
Post subject: 
It is the entire switch. I have figured out how though. I grouped the wires in 2 and feed a piece of mechanics wire down then pulled 1 group thru then the other. The problem that I am now dealing with is the new turn signal switch which I got from freddick dodge, is that it is larger than the original one so I have spent the last 2 hours with my dremel brinding out the inside of my column where the cam hits the inside of the column when it turns > AAAAAHHHHHHHHHHHHHHH next time I will try JUST REPLACING the cam. :evil:
Author:  Chuck [ Thu Feb 24, 2005 5:08 pm ]
Post subject: 
I have cams for the '64 style switch if anyone needs them. I'm not sure how late they can be used.
Author:  SlantSixDan [ Thu Feb 24, 2005 5:31 pm ]
Post subject: 
The '64-style switch is '64 through '68, but can be used as far back as '62. The difference between the '62-'63 and '64-'68 switch is the style of terminals on the ends of the wires.
Page 1 of 1 All times are UTC-07:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/