| Slant Six Forum https://www.slantsix.org/forum/ |
|
| Plug on back of clifford manifold https://www.slantsix.org/forum/viewtopic.php?t=12313 |
Page 1 of 1 |
| Author: | Pierre [ Sun Mar 20, 2005 7:31 pm ] |
| Post subject: | Plug on back of clifford manifold |
On the backside of the plenum (facing the drivers fender) theres a plug there. Any idea what that was meant for? It would be a perfect location for a manifold air temp sensor for my ms setup. Its 3/4" npt, right? |
|
| Author: | steponmebbbboom [ Sun Mar 20, 2005 8:55 pm ] |
| Post subject: | |
3/4" NPT is HUGE. Are you sure? NPT dimensions refer to the inside diameter of the pipe fitting. If the hole is 3/4" in diameter I would guess that it is 3/8"? but you should take the plug with you to Brafasco or something and have them identify it to be sure. |
|
| Author: | Pierre [ Sun Mar 20, 2005 9:11 pm ] |
| Post subject: | |
Whoopsy, brain fart, yeah 3/8" npt, I was thinking 3/4" because thats what the size of the hex nut on the sensor I was thinking of using. |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|