Slant Six Forum
https://www.slantsix.org/forum/

rod bearings mis hap???
https://www.slantsix.org/forum/viewtopic.php?t=12479		 Page 1 of 1
Author:  mopargirlnc [ Sat Apr 02, 2005 4:55 pm ]
Post subject:  rod bearings mis hap???
Does anyone know the part number since autozone and advance cant get me the right bearings for a standard 225 ???? Any help would be so appreciated!!! Thanks
Author:  SlantSixDan [ Sat Apr 02, 2005 5:15 pm ]
Post subject: 
What year engine are you working on? What, if anything, has been done to the crankshaft?
Author:  steponmebbbboom [ Sat Apr 02, 2005 5:42 pm ]
Post subject: 
I would have to add, what undersize (if any) have the rod journals been ground to and are the journals damaged? Because if the rod journal is wiped, you are going to either have to regrind or replace the crank. Dont bother picking up any bearings until (or unless) you know this.
Author:  Charrlie_S [ Sat Apr 02, 2005 8:32 pm ]
Post subject: 
1960-1975 forged crank-
Michigan & Michigan 77: CB606-xx or 7375-xx
TRW: 2375-xx
Sealed Power: 2375CP-xx

1976-1986 Cast Crank-
Sealed Power: 3695RA-xx

xx= the undersize demension in thousands of an inch. Such as 10, 20, etc.
Author:  SlantSixDan [ Sat Apr 02, 2005 8:33 pm ]
Post subject: 
Good P/N info -- remember, the forged/cast crank changeover was in midyear '76.
Author:  ZacharyB [ Sat Apr 02, 2005 10:15 pm ]
Post subject: 
Quote:
Good P/N info -- remember, the forged/cast crank changeover was in midyear '76.
I would assume he would want to get a forged crankshaft in the event of damage? Or is it a matter of a cast crankshaft fitting a later block?
Author:  Charrlie_S [ Sun Apr 03, 2005 5:45 am ]
Post subject: 
The forged crank cannot be installed in the cast crank block. The block, crank, and rods are unique to each other.
Author:  steponmebbbboom [ Sun Apr 03, 2005 4:23 pm ]
Post subject: 
Quote:
I would assume he
COUGH *ahem*
Page 1 of 1 All times are UTC-08:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/