| Slant Six Forum https://www.slantsix.org/forum/ |
|
| coating/painting aluminum intake https://www.slantsix.org/forum/viewtopic.php?t=13124 |
Page 1 of 1 |
| Author: | JohnnyDees [ Tue May 24, 2005 4:13 pm ] |
| Post subject: | coating/painting aluminum intake |
I was thinking of painting/coating my offy 2 x 1 manifold red. But have never had luck with aluminum manifolds and painting. Will powder coating hold up? Has anyone done this? |
|
| Author: | SlantSixDan [ Tue May 24, 2005 4:14 pm ] |
| Post subject: | |
Powder coating will hold up fine. |
|
| Author: | Slantosis [ Tue May 24, 2005 7:03 pm ] |
| Post subject: | |
I used duplicolor brand hi temp red paint on my clifford mainfold and the entire engine. I looks great and has held up perfectly |
|
| Author: | JohnnyDees [ Thu May 26, 2005 7:44 am ] |
| Post subject: | |
Slantosis - Did you use a primer or sealer on the intake? Or any other special prep work? |
|
| Author: | Al T [ Thu May 26, 2005 11:35 am ] |
| Post subject: | Paint Prep |
I had a buddy spray hi-build epoxy primer before painting and it was remarkable how much it smoothed the rough casting surfaces. Final surface always reflects the quality of prep work. |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|