| Slant Six Forum https://www.slantsix.org/forum/ |
|
| Header Flanges https://www.slantsix.org/forum/viewtopic.php?t=13443 |
Page 1 of 1 |
| Author: | Will [ Thu Jun 23, 2005 4:03 pm ] |
| Post subject: | Header Flanges |
Who was making the stainles header flanges? Will |
|
| Author: | Doctor Dodge [ Thu Jun 23, 2005 9:08 pm ] |
| Post subject: | |
Did you try Burns Stainless? http://www.burnsstainless.com/ If they don't have the SL6 flange they would know of a shop that would make one. DD |
|
| Author: | Tom Drake [ Fri Jun 24, 2005 3:48 am ] |
| Post subject: | |
We had to have ours cut out by a local shop. Same guy who made the burns stainless exhaust. You should be able to find some one local to do it for you. Tom |
|
| Author: | Charrlie_S [ Fri Jun 24, 2005 6:20 am ] |
| Post subject: | |
Will Contact Kevin at http://www.crank-scrapers.com/ and ask him. He did mild steel flanges for me. They are not listed on the website, you will have to call or e-mail. |
|
| Author: | Will [ Mon Jun 27, 2005 5:11 am ] |
| Post subject: | |
Thanks everyone. Will |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|