I finally tracked down one of these hard to find gears. I have what I think is the clip that holds it on. The old gear broke when I pulled the cable from the tranny.

I can't figure out how to clip the new gear on. It has a slot on each side that I suppose the clip goes into. But there is no way I can see the clip fully seating. I'm sure I just don't know how it goes on. The clip looks like a "c". The slots in the gear are at the base.

I hope someone has a clue about what I'm talking about.
Thanks

_________________
"Nothing in all creation is hidden from God's sight. Everything is uncovered and laid bare before the eyes of Him to whom we must give account."

Has anyone ever install a pinion gear on a '64, manual tranny?
How about a pic of the retaining clip so I can tell if I have the right one (baby)?

_________________
"Nothing in all creation is hidden from God's sight. Everything is uncovered and laid bare before the eyes of Him to whom we must give account."

did you ever get it installed? I can get you a pic of one still installed though email (69dartcv@cox.net), Lawrence