IIRC, there is only one company that makes lifters anymore anyway. Everyone else just has their name put on them.
| Slant Six Forum https://www.slantsix.org/forum/ |
|
| opinions on tappets https://www.slantsix.org/forum/viewtopic.php?t=14211 |
Page 1 of 1 |
| Author: | sick6 [ Tue Aug 30, 2005 7:34 pm ] |
| Post subject: | opinions on tappets |
I figure this doesn't come up too often, but since I am rebuilding the whole baby soon, does anyone have a brand of mechanical tappets they recomend? build up: 1975 225 block mucho head work (huge valves, port and polish, shaved .090) dual roller chain 390 holley 11 to 1 compression clifford intake and headers and eventually the GM HEI conversion. I will most likely need to have custom pushrods, so if anyone has a particular brand they recomend for them let me know that also if you could. -thanks..... |
|
| Author: | Greg Ondayko [ Wed Aug 31, 2005 10:28 am ] |
| Post subject: | |
I got a new set from advance auto cost $4 and change a lifter - for about $80 total, had no problems - I think they are sealed power brand. Greg |
|
| Author: | slantzilla [ Wed Aug 31, 2005 11:28 am ] |
| Post subject: | |
IIRC, there is only one company that makes lifters anymore anyway. Everyone else just has their name put on them.
|
|
| Author: | sick6 [ Thu Sep 01, 2005 1:56 pm ] |
| Post subject: | |
figures. anyone have any recommendations for pushrods? |
|
| Author: | slantzilla [ Thu Sep 01, 2005 2:35 pm ] |
| Post subject: | |
Quote: figures.
www.pushrods.net
anyone have any recommendations for pushrods? |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|