| Slant Six Forum https://www.slantsix.org/forum/ |
|
| Throttle Linkage for Aoffenhauser https://www.slantsix.org/forum/viewtopic.php?t=14332 |
Page 1 of 1 |
| Author: | bwhitejr [ Sat Sep 10, 2005 4:04 pm ] |
| Post subject: | Throttle Linkage for Aoffenhauser |
I have a cable type throttle linkage on my D-150 Dodge Truck and I want to hook up the throttle on my Offenhauser 4 bbl manifold. Th end of the cable looks like a little clevis bolt. I will also need the clamp assembly which mounts somewhere. Does someone make the parts I need? The carburetor is a Holley 390 cfm. I hav e the 20-7 part from Holley what else do I need? Thanks in advance |
|
| Author: | chi/6er [ Mon Sep 12, 2005 12:42 am ] |
| Post subject: | throttle linkage |
I am not sure if you need that Holley part 20-7(lever extension). But I believe you are looking for a throttle lever stud, part number 510-20-38 or 510-20-37(short). your cable should fit over stud like the stock arrangement. if you need the part to hold the throttle cable, I think you can use the stock setup. Someone else would need to verify this..Jerry |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|