Finally I had my cam grinder givin me a copy of the profile he used on my cam and found out that wasn't a shivvy hidrolic profile
I set lash to .38 mm intake .45 mm ex and I got a healty happy mill that likes to pull all over the place.
My temp dropped down quite a bit and the acceleration is even and nice. I may have my cam retarded or my timing chain stretched cuz it seems to kick in between 50 - 80 mph. (80 and 130 kmh) I mean, it ain't bad on the low end but nothing comes close to me when I step on it at that range.
Thanks to Doc, Lou, SSD, and many others that have shared my frustration and given me good advice.