Well, you start by pulling the balancer off you just put on.....
| Slant Six Forum https://www.slantsix.org/forum/ |
|
| plastic pieces in engine https://www.slantsix.org/forum/viewtopic.php?t=14757 |
Page 1 of 1 |
| Author: | spamman450 [ Thu Oct 20, 2005 12:38 am ] |
| Post subject: | plastic pieces in engine |
i installed my harmonic balancer on my slant this weekend by tapping it on with a plastic hammer and a pice of wood. when i looked in the oil pan there where several tiny pieces of plastic that where not there before the install. i asuume i banged them loose from somwhere. any ideas? |
|
| Author: | GTS225 [ Thu Oct 20, 2005 3:13 am ] |
| Post subject: | |
Take a careful look at your distributor drive gear. Also, did/do you have the cam timing sprocket that has the plastic teeth? Roger |
|
| Author: | Charrlie_S [ Thu Oct 20, 2005 4:39 am ] |
| Post subject: | |
Nylon teeth from the cam sprocket? |
|
| Author: | spamman450 [ Thu Oct 20, 2005 10:07 am ] |
| Post subject: | |
the distributor was not in the motor at the time. is the cam timing sprocket hard to replace? |
|
| Author: | slantzilla [ Thu Oct 20, 2005 2:27 pm ] |
| Post subject: | |
Well, you start by pulling the balancer off you just put on.....
|
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|