i installed my harmonic balancer on my slant this weekend by tapping it on with a plastic hammer and a pice of wood. when i looked in the oil pan there where several tiny pieces of plastic that where not there before the install. i asuume i banged them loose from somwhere. any ideas?

Take a careful look at your distributor drive gear. Also, did/do you have the cam timing sprocket that has the plastic teeth?

Roger

Nylon teeth from the cam sprocket?

_________________
Charrlie_S
65 Valiant 100 2dr post 170 turbo
66 Valiant Signet 170 nitrous
64 Valiant Signet
64 Valiant 4dr 170
64 Valiant 4dr 225

the distributor was not in the motor at the time. is the cam timing sprocket hard to replace?

Well, you start by pulling the balancer off you just put on.....

_________________
Official Cookie and Mater Tormentor.