Sounds like a redo of the Green bearing kit. I have run Green bearings on the street for years.
| Slant Six Forum https://www.slantsix.org/forum/ |
|
| new MP rear axle bearing set https://www.slantsix.org/forum/viewtopic.php?t=14807 |
Page 1 of 1 |
| Author: | Michael [ Mon Oct 24, 2005 11:28 am ] |
| Post subject: | new MP rear axle bearing set |
Has anyone used the "new" axle bearing kit from MP for their 8 3/4? Is it better than the OEM set-up. It claims to do away with the end play adjustment which I've always found to be a bit of a pain. Is this good for a daily driver? Any thoughts are welcome. P.S. This kit is pictured on p.297 of the new Summit cat. Thanks Michael |
|
| Author: | slantzilla [ Mon Oct 24, 2005 12:10 pm ] |
| Post subject: | |
Sounds like a redo of the Green bearing kit. I have run Green bearings on the street for years.
|
|
| Author: | Ron Parker [ Tue Oct 25, 2005 7:08 pm ] |
| Post subject: | |
Yep thats the deal do it.  Thanks Ron ParkerHey Has That Thing Got A Bagel Bamboozler In It |
|
| Author: | dusty7t4 [ Tue Oct 25, 2005 7:44 pm ] |
| Post subject: | |
either way, pressin bearings is a pain. not as bad as replacing upper control arm bushings, but right up there none the less. -dave |
|
| Author: | guest [ Thu Oct 27, 2005 9:49 am ] |
| Post subject: | |
When I got my 8 3/4, it had 1 green bearing and 1 stock. I wanted maximum robustness, so I decided to go to stock on both, but the cover plates had been badly damaged. I could get the bearings and seals anywhere, but the covers were difficult to find and I bought 2 factory kits from Year One. Each kit has the covers for BOTH sides; you only need one kit to get both covers. That only left he adjustment lock tang; I never found a source for it and got one from scrap axle. |
|
| Page 1 of 1 | All times are UTC-07:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|