| Slant Six Forum https://www.slantsix.org/forum/ |
|
| Main and rod bearing widht https://www.slantsix.org/forum/viewtopic.php?t=15142 |
Page 1 of 1 |
| Author: | Kent [ Thu Nov 24, 2005 12:15 pm ] |
| Post subject: | Main and rod bearing widht |
Can someone tell me what the widht on the main and rod bearing at pre77 and post77 /6engines are? Please... /Kent |
|
| Author: | Charrlie_S [ Fri Nov 25, 2005 8:23 am ] |
| Post subject: | |
I have been looking for my bearing book, to get the dimensions, but it is misplaced at this time. The forged crank 1, 2, 4, width is slightly more then 1 inch. The cast crank bearing width is less then 1 inch. |
|
| Author: | relic-lover [ Fri Nov 25, 2005 11:54 am ] |
| Post subject: | Forged crank rod bearing size |
From the 63 Dart factory shop manual For a forged crank motor : Rod bearings are 2.1870 inch diameter x 1.015 inch length Mains were not specified |
|
| Author: | Kent [ Mon Nov 28, 2005 4:12 am ] |
| Post subject: | |
Thank you for the help, now I will have a better idea what to look for. /Kent |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|