Slant Six Forum
https://www.slantsix.org/forum/

Unfortunate Electronic Ignition Question
https://www.slantsix.org/forum/viewtopic.php?t=15149
Page 1 of 1

Author:  Daddiojoe [ Fri Nov 25, 2005 1:34 pm ]
Post subject:  Unfortunate Electronic Ignition Question

My electronic ignition kit from my friends on Ebay arrived without instructions. It all looks pretty simple, except for three wires.

Where does the blue striped w/yellow wire go?

Where does the green striped w/ red wire go?

Where does the black striped w/ yellow go?


Thanks very much and hope you all had a great T' giving,

Joe

Author:  Eric W [ Fri Nov 25, 2005 4:44 pm ]
Post subject: 

The black w/yellow tracer goes to the negitive post of the coil, the blue w/yellow tracer goes to the run side of the ballast resister. Green w/red tracer is not used. Just cut and cover it with tape. This is assuming your using this with a single ballast resister, not the dual resister. Yes, you can use a 5 pin ECU with a single resister.

Author:  Daddiojoe [ Sun Nov 27, 2005 8:52 am ]
Post subject: 

Thanks, Eric. We'll see how that works.

Joe

Page 1 of 1 All times are UTC-08:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/