Slant Six Forum
https://www.slantsix.org/forum/

What Length Pushrod?
https://www.slantsix.org/forum/viewtopic.php?t=16210		 Page 1 of 1
Author:  Walter Lee Jackson [ Thu Feb 16, 2006 7:04 pm ]
Post subject:  What Length Pushrod?
I converted my 225 to hydraulic lifters using the Clifford Performance kit. (cam, lifters, springs).

The head was shaved 0.100 and the springs are set to the factory height.

I'm ready to order new pushrods. I know I can obtain an adjustable pushrod and set it at the correct length and then order a set of pushrods made to that length, but I'd like to avoid that step, if possible. Or am I just kidding myself?

Does anyone know what length pushrod I should order, or do I need to measure?

Thanks.

--Walt Jackson
Author:  james longhurst [ Thu Feb 16, 2006 7:15 pm ]
Post subject: 
walter-

call smith brothers (pushrods.net?) they make great pushrods and they can tell you exactly how to measure for this. be sure you have the proper hydraulic rockers and get pushrods that will feed oil to the top end from the lifters.
they made a beautiful set for my 318 (hydraulic cam with mechanical roller rockers) and i had them in less than a week.

-james
Author:  sandy in BC [ Thu Feb 16, 2006 7:17 pm ]
Post subject: 
Not again......!
Author:  james longhurst [ Thu Feb 16, 2006 7:21 pm ]
Post subject: 
Quote:
Not again......!
yes. again... :P

-james
Author:  Dave [ Tue Nov 21, 2006 8:33 pm ]
Post subject:  pushrod length
Stumbled on to your rather dated post. I too have rodded my '82 hyraulic lifter slant six and am now looking for pushrods. What length did you end up using, and where did you buy them?

Thanks,
Dave
Author:  Walter Lee Jackson [ Wed Nov 22, 2006 1:14 am ]
Post subject:  What Length Pushrod?
Dave,

I haven't yet.

Too busy with other projects.

Probably won't get back to the car until spring.

Alas!!!

--Walt Jackson
Page 1 of 1 All times are UTC-08:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/