| Slant Six Forum https://www.slantsix.org/forum/ |
|
| just some questions. https://www.slantsix.org/forum/viewtopic.php?t=16969 |
Page 1 of 1 |
| Author: | psychodieseltech1348 [ Sun Apr 09, 2006 8:11 am ] |
| Post subject: | just some questions. |
First off I am putting together a slant it will be ported/polished and have a 264 dur/470 lift cam, offy four barrel intake and a 500cfm edelbrock carb. The rest of the engine is stock. My questions are as follows. 1. the engine is a remanufactured unit and I would like to shave to head.the problem is what would be safe to shave off if it has already been shaved buy the rebuild place. Also I not sure if the block has been decked. I can find no markings. I believe the block has been decked because the stamping are gone off the block deck. 2. Is there any measurements as far as thickness i can take of the head to tell if it has been shaved or will I have to cc the head if this will tell me anything. 3. What are the piston to deck measurements so I can tell if the block has been decked. 4. Also will I have interference with this lift on the cam with the pistons if i shave the head and the block had been decked. Hope I didn't ask to stupid of questions. Oh I forgot this is a 225 in a 1980 shortbox D150 with a 904 trans. Thank you the mad scientist |
|
| Page 1 of 1 | All times are UTC-07:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|