The ones at my local muffler shop have slotted bolt holes, so they fit different bolt spacing. And they're only a buck or two each. Heck, one time they just GAVE one to me.
And you wanna go scrounge a JY for one...?
VM
| Slant Six Forum https://www.slantsix.org/forum/ |
|
| exhaust flange for dutras https://www.slantsix.org/forum/viewtopic.php?t=17124 |
Page 1 of 1 |
| Author: | mopar_nocar [ Tue Apr 18, 2006 10:38 am ] |
| Post subject: | exhaust flange for dutras |
what exhaust flange can be used with the Dutra Exhaust Manifold? i have one for my 65 exhaust manifold, but it doesn't fit the Dutra.... any ideas where i can get the one i need? sb |
|
| Author: | vynn3 [ Tue Apr 18, 2006 11:22 am ] |
| Post subject: | |
Your nearest muffler shop? That's where I get mine... VM |
|
| Author: | mopar_nocar [ Tue Apr 18, 2006 11:25 am ] |
| Post subject: | |
any idea what car they fit? sb |
|
| Author: | SlantSixDan [ Tue Apr 18, 2006 11:41 am ] |
| Post subject: | |
They're not vehicle-specific. Exhaust flanges are exhaust flanges. They have a centre hole for the pipe, and two bolt holes. They differ only in the sizing of the centre hole and the spacing of the bolt holes. |
|
| Author: | mopar_nocar [ Tue Apr 18, 2006 12:03 pm ] |
| Post subject: | |
ok; i realize what you are saying....BUT if i go out to the junkyard and try to measure every exhaust flange i find, i might find it on the first try or the 1000th or not at all...i would like to go out to the pick and pull and get a short section of head pipe from say a 1980 Dodge with a slant six, or a Mitsubishi 4 banger etc etc, so i can do up my own exhaust. i have the measurements for the Dutra outlet, and i know for a fact the flange off my 65 won't bolt up, but if anyone can tell me where to get the flange (online listing by measurement?) i would be glad to buy just that and let someone else do the exhaust...OR if need be go JYing and chop out the section i need. |
|
| Author: | SlantSixDan [ Tue Apr 18, 2006 12:43 pm ] |
| Post subject: | |
It will be much easier to source the flange as a new part. Good exhaust shops have dozens of different ones! |
|
| Author: | vynn3 [ Wed Apr 19, 2006 5:59 am ] |
| Post subject: | |
The ones at my local muffler shop have slotted bolt holes, so they fit different bolt spacing. And they're only a buck or two each. Heck, one time they just GAVE one to me. And you wanna go scrounge a JY for one...? VM |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|