| Slant Six Forum https://www.slantsix.org/forum/ |
|
| Crane Cams https://www.slantsix.org/forum/viewtopic.php?t=17496 |
Page 1 of 1 |
| Author: | Mel Ott [ Wed May 10, 2006 10:16 am ] |
| Post subject: | Crane Cams |
Does anyone have an old Crane Cams catalog, around 1990 vintage ?? I have a Crane Cam in my Slanter installed I think in 1990. The car was in storage for about 15 years and all the specs on the cam shaft have gone away. I seem to remember it being around 270 or 280 duration (not sure). I get a rough idle at around 900 rpm ( won't run under that). If anyone has a catalog and can supply me with some info it would be greatly appreciated. I tried Crane Cams.com but found nothing, apperently they don't make a cam for the Slant 6 anymore. |
|
| Author: | Charrlie_S [ Wed May 10, 2006 11:34 am ] |
| Post subject: | |
Mel, is there any chance that cam could be the F-274? I have the cam card for that cam. |
|
| Author: | Mel Ott [ Wed May 10, 2006 3:18 pm ] |
| Post subject: | |
Quote: Mel, is there any chance that cam could be the F-274? I have the cam card for that cam.
Sounds about right.........When I ordered the cam, I wanted as much cam as I could get and still get some kind of idle with my auto trans. I would think anything much more than that and the engine would get rather lumpy.... so ya, I'd say thats probably it. If you could scan it and EMail it to me I'd appreciate it. |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|