don't know much about 6 bangers
I see these super six in parts yard all the time
what's the deal with them
| Slant Six Forum https://www.slantsix.org/forum/ |
|
| super six https://www.slantsix.org/forum/viewtopic.php?t=19220 |
Page 1 of 1 |
| Author: | aa-1159 [ Wed Aug 16, 2006 5:29 pm ] |
| Post subject: | super six |
don't know much about 6 bangers I see these super six in parts yard all the time what's the deal with them
|
|
| Author: | Reed [ Wed Aug 16, 2006 5:37 pm ] |
| Post subject: | |
http://www.slantsix.org/articles/supersix/article.htm Welcome! |
|
| Author: | aa-1159 [ Wed Aug 16, 2006 5:50 pm ] |
| Post subject: | super six |
thanks for the web site looks like I'll be pulling super six parts, instead of letting them get scraped 
|
|
| Author: | Reed [ Wed Aug 16, 2006 5:57 pm ] |
| Post subject: | |
Just make sure you get EVERYTHING! (1) intake manifold (2) carb (3) choke pulloff assembly (4) air cleaner (5) fuel inlet line (6) kickdown assembly, including lever on transmission (7) header pipe, if possible (8) gas pedal and throttle cable (never hurts) (9) distributor (Super Six advance curve) |
|
| Author: | dakight [ Wed Aug 16, 2006 7:00 pm ] |
| Post subject: | |
You can likely sell them as fast as you can pull them. |
|
| Author: | reddart64 [ Thu Aug 17, 2006 7:29 am ] |
| Post subject: | |
In fact, I would be interested in a whole set - If the price is right! 
|
|
| Author: | rebel_cat68 [ Sat Aug 19, 2006 10:02 am ] |
| Post subject: | |
Out of quriosity. What is the going rate nowadays over there for a working supersix carburetor + intake/exhaust manifold and maybe an aircleaner? |
|
| Author: | HyperValiant [ Sat Aug 19, 2006 10:44 am ] |
| Post subject: | |
Sometimes its better to buy the whole car.In the last 8 months I have bought a 78 4dr Aspen with supersix but carb was bad for $25 and $25 tow bill and a running 79 Volare with supersix for $50. So,for $100 I got 2 complete cars and got $75 out of the Aspen at the crusher,ended up with $25 in 2 supersix setups,one aluminum and one cast iron. HyperValiant |
|
| Author: | sunshine6 [ Sat Aug 19, 2006 1:46 pm ] |
| Post subject: | |
I'll second that, reddart! |
|
| Author: | rebel_cat68 [ Sun Aug 20, 2006 3:19 am ] |
| Post subject: | |
Wau. Here I have to pay about $100-150 for the stuff I mentioned above. The going rate for a hole car starts at about $1000, and it can be just "junk". |
|
| Author: | HyperValiant [ Sun Aug 20, 2006 2:55 pm ] |
| Post subject: | |
Rebel_Cat68,around these parts,$750 will buy you a decent running Volare or Aspen. HyperValiant |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|