| Slant Six Forum https://www.slantsix.org/forum/ |
|
| Intake/Exhaust manifold gasket https://www.slantsix.org/forum/viewtopic.php?t=20364 |
Page 1 of 1 |
| Author: | reddart64 [ Thu Oct 19, 2006 3:18 pm ] |
| Post subject: | Intake/Exhaust manifold gasket |
Mine needs to be replaced and I was wondering if there are any "gottchas" involved or is it pretty straight forward? Any assistance is always appreciated. Geoff |
|
| Author: | Jeb [ Thu Oct 19, 2006 7:02 pm ] |
| Post subject: | |
The Manifold installation article in the articles section of this site will answer all of your questions. |
|
| Author: | oldgoat83 [ Fri Oct 20, 2006 3:49 pm ] |
| Post subject: | |
I started on mine today. Due to my great mechanical skills, patience and shear genius, I managed to NOT break any of the manifold studs or lose any of the triangle washers. I did however break two of the intake/exhaust rods that hold them together. I also sheared off the nuts from the exhaust manifold to the exhaust pipe. I now have an unusable vehicle, and I feel great. Any suggestions on cleaning the aluminum intake? I was originally going to sand blast it. But I'm not sure. I don't want it too smooth as I would like to paint it before I reassemble. |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|