i am putting evrything together and almost ready to put my slant 6 back in my '61 d100. i have one "bracket" that i can't remember where it goes. i have one bracket on either side of the block that attaches to the motor mts. i have the 2 mounts on the bell housing. that leaves me one sort of triangular bracket that looks a little like the block brackets and i don't remember where it goes. ring a bell?

It attaches to the lower drivers side of the block by the pan rail, and should bolt up to two bolt holes in the bellhousing (depending on your starter location it's below the high mount starter, or above the low mount starter).

-D.Idiot

that was it. thanks for the info.