| Slant Six Forum https://www.slantsix.org/forum/ |
|
| where does this go? https://www.slantsix.org/forum/viewtopic.php?t=20837 |
Page 1 of 1 |
| Author: | fikey [ Wed Nov 22, 2006 3:26 pm ] |
| Post subject: | where does this go? |
i am putting evrything together and almost ready to put my slant 6 back in my '61 d100. i have one "bracket" that i can't remember where it goes. i have one bracket on either side of the block that attaches to the motor mts. i have the 2 mounts on the bell housing. that leaves me one sort of triangular bracket that looks a little like the block brackets and i don't remember where it goes. ring a bell? |
|
| Author: | DusterIdiot [ Wed Nov 22, 2006 4:30 pm ] |
| Post subject: | Bellhousing to block gusset... |
It attaches to the lower drivers side of the block by the pan rail, and should bolt up to two bolt holes in the bellhousing (depending on your starter location it's below the high mount starter, or above the low mount starter). -D.Idiot |
|
| Author: | fikey [ Thu Nov 23, 2006 9:56 am ] |
| Post subject: | re |
that was it. thanks for the info. |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|