| Slant Six Forum https://www.slantsix.org/forum/ |
|
| 3 Angle Valve Job https://www.slantsix.org/forum/viewtopic.php?t=21253 |
Page 1 of 1 |
| Author: | ROADRUNNER7169 [ Fri Dec 29, 2006 7:37 am ] |
| Post subject: | 3 Angle Valve Job |
This might be a stupid question but I cant seem to find it in the search section does anyone know the 3 angles you grind a /6 valve at for a 3 angle valve job (my dad used to own a speed shop so I have a valve grinder and all that good stuff for building heads) |
|
| Author: | mpgmike [ Fri Dec 29, 2006 8:53 am ] |
| Post subject: | |
60 - 45 - 30 is always a safe bet when in doubt. |
|
| Author: | 74W100/6 [ Mon Jan 01, 2007 5:06 pm ] |
| Post subject: | Valve job |
I rebuild heads for a living. Unless your valves are cut at 30 degrees instead of 45 you always grind 30-45-60. Its also safe to grind 35-45-60. In the event that your valves were cut at 30 degrees (slants arent) you would grind 15-30-45. |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|