| Slant Six Forum https://www.slantsix.org/forum/ |
|
| Dorman studs & nuts source https://www.slantsix.org/forum/viewtopic.php?t=22649 |
Page 1 of 1 |
| Author: | Jopapa [ Tue Apr 10, 2007 12:05 pm ] |
| Post subject: | Dorman studs & nuts source |
I've looked at Summit, Vato Zone, Schmuck's, Jegs and Napa and had no luck finding the correct studs (or nuts) for my Duster's cylinder head. Anyone know of a source that still sells the right parts? I've looked 'em up by P/N on each site, and gotten nothing. |
|
| Author: | dakight [ Tue Apr 10, 2007 12:18 pm ] |
| Post subject: | |
Go into the store; they may not be listed on the web site. NAPA would be my first choice. Failing that, try a nut and bolt supply company. They are really nothing special so just take a sample with you. Just remember that the coarse thread end goes into the head and the nuts are need for the fine thread end. I believe they are 5/16 but I don't recall the length. |
|
| Author: | SlantSixDan [ Tue Apr 10, 2007 12:42 pm ] |
| Post subject: | |
Rockauto will have 'em, but so will a fastener supply store. They're double-ended 5/16" fine-thread/coarse-thread, 2" overall length if I'm not mistaken. |
|
| Author: | slantfin [ Tue Apr 10, 2007 1:54 pm ] |
| Post subject: | |
I got mine at 'Vato Zone' but had to go behind the counter and they had one less than I needed, why is that always the case? Vato Zone, I think they just got a new nickname. hee hee. |
|
| Author: | VDART [ Tue Apr 10, 2007 6:45 pm ] |
| Post subject: | studs |
any ace hardware stores close by-- they should have them!! |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|