My $.02 is that if it wasn't leaking, a continuous old gasket would be better than a compromised new one. Three of a kind beats two pairs.
| Slant Six Forum https://www.slantsix.org/forum/ |
|
| In car cam swap question https://www.slantsix.org/forum/viewtopic.php?t=23619 |
Page 1 of 1 |
| Author: | skraecken [ Sat Jun 16, 2007 1:25 pm ] |
| Post subject: | In car cam swap question |
Today I did my first in car cam swap, everything went fine, But I got one question, I was not able to pull out the oilpump completely. Can I reuse the old gasket or should I cut the upper end on a new gasket and then put it in place? (Melling lifters, regrinded cam 272 0,420 110) |
|
| Author: | slantfin [ Sat Jun 16, 2007 2:02 pm ] |
| Post subject: | leave it |
My $.02 is that if it wasn't leaking, a continuous old gasket would be better than a compromised new one. Three of a kind beats two pairs.
|
|
| Author: | skraecken [ Sun Jun 17, 2007 9:24 am ] |
| Post subject: | |
Quote: Three of a kind beats two pairs.
Sounds ok, I will go for that. Thanks.
|
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|