| Slant Six Forum https://www.slantsix.org/forum/ |
|
| Head gesket question https://www.slantsix.org/forum/viewtopic.php?t=24016 |
Page 1 of 1 |
| Author: | stolan83 [ Wed Jul 11, 2007 11:04 pm ] |
| Post subject: | Head gesket question |
I just set my head gasket on the block to see if by new bore Dia was bigger then the holes in the gasket, and I do have a little over hang, Should I worry about or is it ok |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|