I don't have mine running yet, I've had the manifold installed to check clearances, it seams to be fine. I just need to wire up the fuel injection. It's a throttle body from a 4.0 Jeep.
| Slant Six Forum https://www.slantsix.org/forum/ |
|
| What size TB is ... https://www.slantsix.org/forum/viewtopic.php?t=24098 |
Page 1 of 1 |
| Author: | Mag00 [ Tue Jul 17, 2007 8:36 pm ] |
| Post subject: | What size TB is ... |
suggested for a basicly stock 225/ auto ? anyone have any up and running EFI setups that they care to share details, problems recommendations? Thank you |
|
| Author: | Matt Cramer [ Wed Jul 18, 2007 11:38 am ] |
| Post subject: | |
I'd get one from a comparably sized V6 - a GM 3.8, Ford 3.8, Mopar 3.9. Any of these ought to work if you plan to keep it basically stock except EFI. |
|
| Author: | Rob64GT [ Wed Jul 18, 2007 11:53 am ] |
| Post subject: | |
I don't have mine running yet, I've had the manifold installed to check clearances, it seams to be fine. I just need to wire up the fuel injection. It's a throttle body from a 4.0 Jeep.
|
|
| Author: | ebluetortuga [ Wed Jul 18, 2007 12:03 pm ] |
| Post subject: | |
i plan on using one from a 1992 mustang GT, its about 60mm |
|
| Author: | Joshie225 [ Wed Jul 18, 2007 3:32 pm ] |
| Post subject: | |
A 1996 4.0 Jeep TB is 2.2" or about 56mm. The 60mm Mustang TB should be fine. If you use too large a TB the throttle response gets jumpy and I would think tuning the acceleration enrichment would be troublesome. |
|
| Page 1 of 1 | All times are UTC-07:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|