| Slant Six Forum https://www.slantsix.org/forum/ |
|
| bent push rod, replacing https://www.slantsix.org/forum/viewtopic.php?t=24246 |
Page 1 of 1 |
| Author: | Watercraft 6 [ Fri Jul 27, 2007 6:56 pm ] |
| Post subject: | bent push rod, replacing |
Turns out that #4 exhaust push rod was off it's rocker and in harms way. I need a replacement. Does anyone have a suggestion as to where to get one? thanx. |
|
| Author: | slantzilla [ Fri Jul 27, 2007 8:25 pm ] |
| Post subject: | |
You should be able to get a pushrod at any parts store. They may have to order it though. Autozone used to have them for about $5. |
|
| Author: | Charrlie_S [ Fri Jul 27, 2007 9:26 pm ] |
| Post subject: | |
Send me a PM with your address, and I can send you one for the postage. |
|
| Author: | Watercraft 6 [ Sat Jul 28, 2007 1:27 pm ] |
| Post subject: | How did it happen? |
Thank you for the kind offer. I have already requested one from me local NAPA store, they say it will be here by Tuesday and the cost is reasonable. Could a stuck valve cause this rod to bend? And if so what would be the remedy? Thanx again. |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|