here you go:
regards,Rod
| Slant Six Forum https://www.slantsix.org/forum/ |
|
| Head torque sequence https://www.slantsix.org/forum/viewtopic.php?t=24856 |
Page 1 of 1 |
| Author: | ValiantOne [ Mon Sep 10, 2007 7:27 am ] |
| Post subject: | Head torque sequence |
Hey All, I should be putting the head back on my 225 in the next day or so. I haven't got my service manual for my car yet (ordered on amazon) but I want to get going! Can anyone tell me the sequence for torqing the head? I seem to remember the torque spec being 70-75 ft-lbs. Is that about right? Thank you! Chris |
|
| Author: | Doc [ Mon Sep 10, 2007 9:22 am ] |
| Post subject: | |
70 ft-lbs is fine. Basically, start at the center bolts and work out evenly to each end. The main point is to "squeeze" the gasket out either end so no wrinkles develop. DD |
|
| Author: | walpolla [ Mon Sep 10, 2007 9:48 am ] |
| Post subject: | |
here you go: regards,Rod
|
|
| Author: | ValiantOne [ Mon Sep 10, 2007 9:59 am ] |
| Post subject: | |
Muchos Gracis guys 
|
|
| Author: | 1974duster kev [ Mon Sep 10, 2007 8:06 pm ] |
| Post subject: | |
I have the same book cam in handy when i was being nice and careful with my head. Kevin |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|