| Slant Six Forum https://www.slantsix.org/forum/ |
|
| Light Switch Pull Out Stem Problems https://www.slantsix.org/forum/viewtopic.php?t=24952 |
Page 1 of 1 |
| Author: | bwhitejr [ Mon Sep 17, 2007 7:27 am ] |
| Post subject: | Light Switch Pull Out Stem Problems |
I bought a new light switch and am having trouble getting the pull out stem to back in and stay. I push the button on the side of the switch when I put it in, but it won't latch and operate the switch. Any ideas? bwhitejr |
|
| Author: | SlantSixDan [ Mon Sep 17, 2007 7:40 am ] |
| Post subject: | |
Clean the groove in the switch knob shaft very thoroughly, give it a shot of spray silicone, and try again. You don't need to push the release button when installing the knob, just when removing it. If it still won't stay, you may have a defective new switch. Whose switch (brand) is it? |
|
| Author: | bwhitejr [ Tue Sep 18, 2007 12:48 pm ] |
| Post subject: | |
The brand of the switch: Standard Motor Products bwhitejr |
|
| Page 1 of 1 | All times are UTC-07:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|