| Slant Six Forum https://www.slantsix.org/forum/ |
|
| Exhaust Flapper Spring https://www.slantsix.org/forum/viewtopic.php?t=25162 |
Page 1 of 1 |
| Author: | ValiantOne [ Mon Oct 01, 2007 5:27 pm ] |
| Post subject: | Exhaust Flapper Spring |
Hey All, I need a new spring/coil for the exhaust flapper on my 66 ehxaust manifold. Is there any way I can adapt one from a 79 manifold? I am guessing that NAPA isn't going to have it. Is there a source for new ones? Also what is the little spring for on the other side? Does that jus help to keep the flapper rod centered? Are the flappers welded or brazed to the shaft? I am guessing they are not removable? Thanks guys, Chris E. |
|
| Author: | oldgoat83 [ Mon Oct 01, 2007 6:10 pm ] |
| Post subject: | |
I think I remember Dan saying the little spring was to prevent rattle. I could be wrong in my recollection. |
|
| Author: | rock [ Tue Oct 02, 2007 7:43 am ] |
| Post subject: | I have several sets of NOS springs for each side in a NOSkit |
Hello, PM me. I got several of the NOS kits for flapper valves and several NOS springs sets too. rock '64d100 |
|
| Author: | mrhite65 [ Tue Oct 02, 2007 12:15 pm ] |
| Post subject: | |
How do you get them out of the exhaust? Is the butterfly welded to the shaft? I tried to knock it through but, no budge. |
|
| Author: | 61 V200 [ Tue Oct 02, 2007 12:32 pm ] |
| Post subject: | |
yes, the diverter plate is welded to the shaft |
|
| Page 1 of 1 | All times are UTC-07:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|