| Slant Six Forum https://www.slantsix.org/forum/ |
|
| what is the ideal head and block mill for stock rebuild? https://www.slantsix.org/forum/viewtopic.php?t=25746 |
Page 1 of 1 |
| Author: | 225rt [ Wed Nov 07, 2007 7:53 pm ] |
| Post subject: | what is the ideal head and block mill for stock rebuild? |
What is the idel head and or block mill for a stock compression rebuild. Im looking for pep but m.p.g. Im going to use 254 dur. 435 lift cam. Is stock back cut 3 angle valve job or oversized valves better. Im using a 2bbl carb.Thanks alot guys! |
|
| Author: | Doctor Dodge [ Wed Nov 07, 2007 10:19 pm ] |
| Post subject: | |
http://www.slantsix.org/articles/dutra- ... blocks.htm http://www.slantsix.org/articles/combus ... hamber.htm There are many other good articles posted in the article section of this web site. DD |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|