what is the ideal head and block mill for stock rebuild?

Unanswered topics | Active topics

Home » Board index » Tech Q & A » Engine

All times are UTC-08:00

what is the ideal head and block mill for stock rebuild?

Post new topic Reply to topic

Page 1 of 1

[ 2 posts ]

Print view

Previous topic | Next topic

Author

Message

225rt

Post subject: what is the ideal head and block mill for stock rebuild?

PostPosted: Wed Nov 07, 2007 7:53 pm

Offline

2 BBL ''SuperSix''

Joined: Tue Apr 25, 2006 8:59 pm
Posts: 15
Location: burr ridge illinois
Car Model:

What is the idel head and or block mill for a stock compression rebuild. Im looking for pep but m.p.g. Im going to use 254 dur. 435 lift cam. Is stock back cut 3 angle valve job or oversized valves better. Im using a 2bbl carb.Thanks alot guys!

Top

Profile

Reply with quote

Doctor Dodge

Post subject:

PostPosted: Wed Nov 07, 2007 10:19 pm

Offline

Guru

Joined: Sat Oct 12, 2002 11:22 am
Posts: 3740
Location: Sonoma, Calif.
Car Model: Many Darts and a Dacuda

http://www.slantsix.org/articles/dutra- ... blocks.htm

http://www.slantsix.org/articles/combus ... hamber.htm

There are many other good articles posted in the article section of this web site.
DD