| Slant Six Forum https://www.slantsix.org/forum/ |
|
| Piston Ring End Gap? https://www.slantsix.org/forum/viewtopic.php?t=25862 |
Page 1 of 1 |
| Author: | valiantboy_66 [ Wed Nov 14, 2007 10:00 pm ] |
| Post subject: | Piston Ring End Gap? |
Doc, everything checks out with the pistons (mocked up) valves clear, rods clear, looks good. How about ring end gap? I have 3.50 bore and total seal rings, I plan on shooting 100 shot of spray. Total seal says .021 on end gap on the top ring and .016 on the second ring. What is your input? These are Wiseco forged pistons. |
|
| Author: | Doctor Dodge [ Wed Nov 14, 2007 10:25 pm ] |
| Post subject: | |
I would run .024 on the top ring and stay with .016 on the second ring. DD |
|
| Author: | valiantboy_66 [ Thu Nov 15, 2007 6:46 pm ] |
| Post subject: | |
Thank you doc! I may have a long block tonight! |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|